Federal Process disclaims any liability for untoward results. Federal Process has no control of physical conditions surrounding application conditions. The information presented is in good faith, but results are not guaranteed. All products should be tested and evaluated for a particular purpose prior to use. Read all information on labels and Safety Data Sheets prior to use. And there is a separate Teflon tape designed for. This product is not recommended for use in an oxygen system and not as a sealant for chlorine or other strong oxidizing materials. There is Teflon tape made to seal the threads on gas fittings and to prevent leaks in those connections. Federal Process Corporation is not liable for any damage of any sort including incidental and consequential damages. All warranty claims are limited to replacement of EverSeal at no charge to the customer. No warranty for merchantability or fitness for a particular purpose shall apply. Federal Process Corporation products are warranted against defects in workmanship and materials. This technology is ideal for preventing leaks due to vibration, changing pressures, or changing temperatures. The manufacturer recommends that the user perform internal testing to determine the cure conditions required to provide an adequate seal. Sealants, Thread tapes, Solder, Flux and Pipe Tapes Thread Tapes and Pastes. Reliable thread sealing is achieved as the anaerobic thread sealant cures when confined in the absence of air and contact with metal surfaces. Tub O’Towels, hot soap & water, or alcohol.īutane, Methane, Natural Gas, Propane and R134a refrigerantĮverSeal drying times may vary with the type of material to which it is applied. Take care not to apply too much sealant and never apply additional sealant over non-cured sealant. The sealant should be applied from the root of the threads out to the crown and allowed to dry back. Parts to be coated with Everseal 183 must be completely clean and free of thread cutting oils, parts washing chemicals, or other residues.ĮverSeal 183 should be applied 1-2 threads back from the end and a minimum of 3 middle threads. Everseal 183 should not be exposed to continuous open air and should be transferred into an air-tight vessel once mixed. Stirring or shaking the sealant will restore it to its original consistency. Do not return any unused material to the original container.Įverseal 183 may thicken and/or appear to separate. See SDS for more information.įor best results and a longer shelf life, EverSeal 183 should be stored at moderate temperatures under 80☏. Sealant must be fully cured prior to assembly or testing for a minimum of 24 hours in ambient conditions.Ĭontains no lead, is non-toxic, not a skin sensitizer, non-corrosive, non-radioactive, non-explosive. Always mix well prior to use, may only be applied to threads in good condition that are dry, clean and free from all oils or other type residues.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |